If you are experiencing any “sag” with your side monitors in a triple monitor setup, please see the 2 fixes below depending on how much sag you have….
A. If there is 1 to 1.5cm of sag or less on the side monitors….In short this gives you the ability to lower the middle monitor by 1-1.5cm more.
1) remove your centre monitor
2) rotate the VESA mount 180degs (or turn it upside down)
3) re-attach your monitor
4) loosen the horizontal bolt until you can lower the centre monitor to match your side monitors, or all the way down and then adjust the height of your side monitors to match
B. If there is MORE than 1-1.5cm of sag on the side monitors….
1) remove the affected monitor
2) detach the articulating arm from the connector
3) flip it over and re-attach the arm to the connector
4) attach your monitor and see if you can now align the monitor by using the horizontal bolt to adjust it’s height
5) if you are still not level, then try what is mentioned in the above Section A as well
If neither of the above get’s you sorted, then please email me directly so I can further troubleshoot it with you directly. My email is “my name below” at obutto d0t c0m, and any pics of the issue will be very helpful 🙂
Best regards,
Chris
.
